Move the editor core out of the firmware crate (pinned to the xtensa
target, so it can't run `cargo test`) into a standalone `editor` crate,
with the panel framebuffer + geometry split into a `display` crate. Both
depend only on embedded-graphics + keymap, so the editor is now
host-buildable and unit-tested (8 characterization tests). Firmware links
them and re-exports the geometry from epd.rs; behaviour is unchanged.
The xtensa firmware build was not verified in this environment.
Per keystroke, diff the new frame against the last shown one to find the
changed row band and partial-refresh only those rows instead of all 272.
E-paper update time scales with the gate rows driven, so a single edited
text line refreshes far faster. Windowed in Y only (full width, both
controllers), so the seam/mirroring logic is unchanged. Also drop the
periodic full refresh to every 64 updates — the panel stays visually
clean, so it's now mainly for longevity.
display_frame_partial writes the new image to bank 0x24, runs GxEPD2's
partial waveform (_Update_Part: 0x3C/0x80, 0x21/0x00,0x10, 0x22/0xFF,
0x20), then syncs bank 0x26 so the next partial has a correct baseline.
Like GxEPD2 for this dual-controller panel, the update covers the full
panel with the partial waveform — no windowing, since the waveform time
dominates. Much faster than a full refresh and without the flashing.
Add a thin dual-SSD1683 driver (src/epd.rs, ported from GxEPD2's
GxEPD2_579_GDEY0579T93) for the 792x272 e-paper panel: reset/init,
RAM addressing, the split-and-mirror full-frame blit across the
master/slave seam at x=396, and full-refresh waveform. Frame
implements embedded-graphics' DrawTarget.
Replace the Spike 1 blink harness in main.rs with the Spike 2 test:
SPI at 4 MHz over SCK 12 / DIN 11 / CS 7 / DC 6 / RST 5 / BUSY 4,
alternating normal/inverted frames with a seam-straddling circle,
"Typoena", and the build tag. Verified on hardware 2026-07-04.
